Martin-christ Epsilon 2-6D LSCplus Manuel d'utilisateur télécharger pdf (Page 97)

Freeze-dryer EPSILON 2-6 LSCplus

8 Maintenance and service

Version 10/2012, Rev. 1.6 of 16/12/2014 • sb

Translation of the original operating manual

Pos: 208 /20 0 Ch rist/ 360 G T-BA L abo r-Pilot (S TAND ARD MODU LE )/080 W a rtung u nd In stan dhalt ung/ 080 -00 10- 002 0 Vak uum pu mpe @ 25 \mo d_1 404 984 103428_ 68. docx @ 18 4405 @ 3 @ 1



8.1.2 Vacuum pump

NOTE

Please refer to the separate operating manual of the vacuum pump!

The stress of the vacuum pump in conjunction with a freeze-dryer is usually

not very high. This is why the recommendations in this operating manual

may differ from the information that is provided by the pump manufacturers.

Under normal operating conditions, the following maintenance tasks

concerning the vacuum pump must be performed at regular intervals:

• Check the oil level of the vacuum pump once per week. If necessary,

top it up with oil.

• Check the running pump for any unusual noise.

• Ensure that the pump has reached its operating temperature prior to

changing the oil.

• Perform the first oil change after approximately 100 operating hours.

• The other oil changes depend on the operating conditions. In general,

an interval of 500 to 1,000 operating hours is sufficient.

• Please contact the Christ service department if you have any queries

(see chapter 7.3 - "Service contact").

Pos: 209 /01 0 Uni v ersal mod ule/L eerz ei le @ 0\m od_ 120 211624 450 0_0. doc x @ 11 4 @ @ 1

Pos: 210 /20 0 Ch rist/3 60 G T-BA L abo r-Pil ot (S TANDA RDMOD U LE)/0 80 Wa rtun g und In stan dhalt ung/ 080 -00 10- 0030 Öl neb elabsc heid er (Auspuf ffi lter ) @ 25\ mod _14 0498410 452 1_6 8.d ocx @ 1844 19 @ 3 @ 1



8.1.3 Exhaust filter (oil mist separator)

NOTE

Please refer to the separate operating manual of the vacuum pump and

the exhaust filter!

The oil mist that is emitted by the vacuum pump in quantities that depend

on the working pressure must be led to the outside or to an exhaust hood

or similar. If this is not possible, the pump must be equipped with an

exhaust filter (oil mist separator).

• Observe the liquid level in the collecting vessel of the filter.

• Remove the condensate in time (please refer to the information

provided by the manufacturer in the separate operating manual).

Pos: 211 /01 0 Uni v ersal mod ule/S eit enwec hsel @ 0\m od_ 120 211 624 4312 _0. docx @ 10 5 @ @ 1

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 134 135

Commentaires sur ces manuels

Pas de commentaire

Martin-christ Epsilon 2-6D LSCplus Manuel d'utilisateur Page 97

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Martin-christ Epsilon 2-6D LSCplus